1. Home
  2. Service Check Reference
  3. Cisco Configuration Save Alert Check

Cisco Configuration Save Alert Check

Object Type: Service Check

Service Check Category: System Checks

Passive: No

Description: This SNMP-based service check is used to check if the running configuration of a Cisco device has changed since the last time it was written to the terminal. OmniCenter queries SNMP OID’s from the CISCO-CONFIG-MAN-MIB (.1.3.6.1.4.1.9.9.43). The check will enter a CRITICAL state if the timestamp of the configuration change is greater than 3000 time ticks since the timestamp it received for the last Config Save.

This check also forces OmniCenter to retrieve the latest running configuration from the Cisco device if a configuration change has been detected on the device.

The OID’s used to gather saved and changed configuration timestamps are:

  • Config Save: .1.3.6.1.4.1.9.9.43.1.1.2.0
  • Config Changed: .1.3.6.1.4.1.9.9.43.1.1.3.0

 

Fields:
DESCRIPTION
(Required) This field specifies a name for this check. The name entered must be unique among service check names on the host it is added to (the name may used again only on a different host). It is used to identify this specific check from among other service checks added to the same host.

Updated on November 22, 2019

Was this article helpful?

Need Support?
Can’t find the answer you’re looking for? Don’t worry we’re here to help!
Contact Support

Leave a Reply